VEHICLE TUNING SPECIALISTS

Welcome to our newly revised website.

 

OPTIONAL DASH SWITCH FOR TURBOTUNE MODULES

USES:

• SPORT BUTTON (OPTIONAL CHROME LED PUSH SWITCH AVAILABLE)
• TOWN / COUNTRY
• ECONOMY / POWER
• TOWING / NOT TOWING,
• HIS / HERS !!!
• ICY CONDITIONS
• BEST OF BOTH WORLDS FOR DPF EQUIPPED TOWN CARS

 

FEATURES:

• CAN BE OPERATED WHILST DRIVING.
• SIMPLY PLUGS INTO THE SOCKET ON THE MODULE (Turbotune works in normal (power) mode if not connected)

 

MODES:

• ECO1: A new map designed for best economy and heavy urban use. green led lit ^
• ECO 2 or OFF Like ECO1 but a bit stronger - no leds lit ^
• POWER: This uses the setting determined by the switch on the Turbotune module. Red led lit.

You can switch between the new Eco settings and a POWER setting, WHILST DRIVING. (the actual Power setting is the one currently selected by the Turbotune switches.)  Just change the setting and momentarily lift off the accelerator for the new setting to take effect.

The dash switch requires a thin cable to be fed through from the engine compartment. Often there are unused blanking plugs / grommets or the cable can be fed through an existing one. Until the switch is connected, the module operates in the normal way using the settings of the witches on the Turbotune.

The 3position dash switch can be located in any convenient place and attached with the supplied heavy duty velcro. The alternative high quality chromed brass push button switch with either green, red, or blue led requires a 16mm hole in the dash or centre console.

 

Alternatively, you can use an OEM pushbutton or switch to match the others on your dash. If a pushbutton is used, it MUST be the latching type (push in, push again to release). You can also use illuminated switches or fit your own led elsewhere. See below for more details.

 

If you drive a dpf / particulate equipped vehicle mainly on short urban journeys then you can use the off or eco setting in town and flick the switch when you need more power for overtaking or steep hills. Out of town you can use any setting. [ECO2 can be OFF if requested ]

 

HIGH QUALITY CHROME PUSH BUTTON WITH LED. An alternative to the 3position dash switch

We can supply a kit comprising a high quality chrome plated brass push on, push off switch with led in place of the switch shown above.

• ADJUSTABLE BRIGHTNESS
• OUT = ECO or OFF* IN = POWER
• PRE WIRED KIT - NO SOLDERING REQUIRED.
• SINGLE 16MM HOLE REQUIRED.
• 12V LED SUPPLY IS ISOLATED FROM THE TURBOTUNE
• LED CONTROLLED BY THE TURBOTUNE so you can see when the new setting engages.
• LED COLOUR OPTIONS: RED, GREEN OR BLUE.
• AVAILABLE WITHOUT PUSHBUTTON FOR USE WITH OEM SWITCHES

 

The push button switch kit consists of: Left to right: Led power cable, led adaptor, Turbotune cable, & push button.

The harness is prewired ready to plug in once the push button has been installed.

The red/black wire connects to a 12v and gnd supply eg cig lighter or dash illumination. If this is varied by your car's dash rheostat, then the led will also dim. Current requirement is negligible (5-10ma)

The brightness adjusting screw is visible on the side of the led adaptor. Pre wired connectors - feed the cable from the pushbutton through the 16mm hole drilled in the dash or centre console and plug them onto the male ends, one 2pin, one 3pin so you can't mix them up.

 

USING AN OEM SWITCH OR PUSHBUTTON

Kit is available without the pushbutton so you can use any switch or push button of your choosing. (must be a latching type) It can have an led built in or the led can be remote from the switch or push button. The pushbutton wiring harness is supplied so this just needs connecting to the switch and led.

The 2pin connector is for the switch and the 3pin one for the led (2pins used, 1 spare)

 

INTELLIGENT DESIGN FEATURES ENSURE RELIABLE OPERATION:

The pushbutton will control the mode even f the led supply is not connected or becomes disconnected.

The 12volt LED supply is isolated from the Turbotune by optical switches to prevent damaging battery voltage entering it in the unlikely event of a fault or short within the switch.

The Turbotune will operate in Power mode if the cable becomes detached or damaged. I.e nothing can affect the correct functioning of the Turbotune.

PRICES:

THE 3 POSITION SWITCH MODULE IS £25 EXTRA

THE HIGH QUALITY CHROME PUSH BUTTON WITH EITHER A RED, GREEN OR BLUE LED IS £38 EXTRA

THE SWITCH KIT MINUS A SWITCH IS £20

Not available for some vehicles.

UNIQUE NEW FEATURE